Translations:Power users hub/8/zh-tw: Difference between revisions

Revision as of 08:38, 25 February 2017

Information about message (contribute)

This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.

Message definition (Power users hub)

* [[Scripting_and_macros|Scripting and Macros]] - A list of relevant wiki pages
* [[Introduction_to_Python|Introduction to Python]] - See also other Python tutorials at the bottom of this page
* [[Python_scripting_tutorial|FreeCAD scripting tutorial]] - A general look at Python scripting in FreeCAD
* [[FreeCAD_Scripting_Basics|FreeCAD Scripting Basics]]: Well, the basics
* [[Manual:A_gentle_introduction|FreeCAD Manual - Section Python Scripting]]: Multi-chapter introduction to Python Scripting in FreeCAD
* [[Gui_Command|Gui Command]]: Adding custom commands to the GUI
* Using mixed [[Units|Units]] in FreeCAD
* [[Profiling|Profiling]] the Python code
* [[Debugging#Python Debugging|Debugging]] the Python code
*[[Python_Development_Environment|Python Development Environment]] - A simplistic development environment for Python within FreeCAD

一般主題

介紹 Python - See also other Python tutorials at the bottom of this page
FreeCAD 腳本撰寫教學 - A general look at python scripting in FreeCAD
FreeCAD Scripting Basics: Well, the basics...
Gui Command : Adding custom commands to the GUI
Using mixed Units in FreeCAD

@@ Line 1: / Line 1: @@
 ===一般主題===
-* [[Introduction to Python]] - See also other Python tutorials at the bottom of this page
+* [[Introduction to Python| 介紹 Python]] - See also other Python tutorials at the bottom of this page
-* [[Python scripting tutorial|FreeCAD scripting tutorial]] - A general look at python scripting in FreeCAD
+* [[Python scripting tutorial|FreeCAD 腳本撰寫教學]] - A general look at python scripting in FreeCAD
 * [[FreeCAD Scripting Basics]]: Well, the basics...
 * [[Gui Command]] : Adding custom commands to the GUI