Translations:Draft Pattern/3/en: Difference between revisions

Revision as of 20:38, 21 February 2020

Information about message (contribute)

This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.

Message definition (Draft Pattern)

# Make sure the objects are closed and planar, and do not self-intersect.
# To close a [[Draft_Wire|Draft Wire]], a [[Draft_BSpline|Draft BSpline]], a [[Draft_CubicBezCurve|Draft CubicBezCurve]] or a [[Draft_BezCurve|Draft BezCurve]] set its {{PropertyData|Closed}} property to {{TRUE}}.
# To close a [[Draft_Circle|Draft Circle]] or a [[Draft_Ellipse|Draft Ellipse]] set its {{PropertyData|First Angle}} and {{PropertyData|Last Angle}} properties to the same value.
# Select the objects.
# Switch to the {{MenuCommand|View}} tab of the [[Property_editor|Property editor]].
# The {{PropertyView|Display Mode}} must be set to {{Value|Flat Lines}}.
# Select a {{PropertyView|Pattern}}.
# Optionally change the {{PropertyView|Pattern Size}}. Note that a higher value results in a denser pattern.
# The pattern is not displayed when the objects are selected. Deselect them to check the result.
# Optionally reselect the objects to change the pattern properties.

Select the object
In Combo View → Data: set Make Face to true to make sure the object will have a face to set the pattern
In Combo View → View → Pattern: specify a hatch pattern to fill the wire with
In Combo View → View → Pattern Size: specify the size of the hatch pattern

@@ Line 1: / Line 1: @@
-==How to use==
 # Select the object
 # In Combo View → Data: set Make Face to true to make sure the object will have a face to set the pattern