From FreeCAD Documentation
Revision as of 18:58, 10 November 2014
Information about message (contribute ) This message has no documentation.
If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Draft Pattern ) # Make sure the objects are closed and planar, and do not self-intersect. # To close a [[Draft_Wire|Draft Wire]], a [[Draft_BSpline|Draft BSpline]], a [[Draft_CubicBezCurve|Draft CubicBezCurve]] or a [[Draft_BezCurve|Draft BezCurve]] set its {{PropertyData|Closed}} property to {{TRUE}}. # To close a [[Draft_Circle|Draft Circle]] or a [[Draft_Ellipse|Draft Ellipse]] set its {{PropertyData|First Angle}} and {{PropertyData|Last Angle}} properties to the same value. # Select the objects. # Switch to the {{MenuCommand|View}} tab of the [[Property_editor|Property editor]]. # The {{PropertyView|Display Mode}} must be set to {{Value|Flat Lines}}. # Select a {{PropertyView|Pattern}}. # Optionally change the {{PropertyView|Pattern Size}}. Note that a higher value results in a denser pattern. # The pattern is not displayed when the objects are selected. Deselect them to check the result. # Optionally reselect the objects to change the pattern properties.
Použití
Vyberet objekt
V rozbalovacím pohledu -> Data: nastavte Vytvořit pochu na true abyste zajistili, že objekt bude mít plochy, kde bude vzor
V rozbalovacím pohledu -> Pohled -> Vzor: specifikujte šrafovací vzor pro vyplnění drátů
V rozbalovacím pohledu -> Pohled -> Velikost vzoru: specifikujte rozměr šrafovacího vzoru