Difference between revisions of "Surface Module"
(Marked this version for translation)
(Remove "Thumb" option from image. It will stay in place.)
|Line 28:||Line 28:|
|Line 38:||Line 38:|
Revision as of 02:10, 29 September 2020
The Surface Workbench introduced in FreeCAD 0.17 provides tools to create and modify simple NURBS surfaces. These tools have a similar functionality to the Part Shapebuilder tool when the Face from edges options is used. However, unlike that tool, the tools of the Surface Workbench are parametric and provide additional options. In this respect, the tools in this workbench are similar to features like PartDesign AdditiveLoft and PartDesign AdditivePipe.
Some of the features provided are:
- Creation of surfaces from boundary edges.
- Alignment of the curvature from neighboring faces.
- Constraining of surfaces to additional curves and vertices.
- Extension of faces.
- A mesh can be used as a template to create spline curves on its surface.
The Surface Workbench intends to create faces with shapes, which is not possible to do with the standard tools in other workbenches. The OCCT kernel gives as example a rectangular box with a rounded corners of different radii.
Surface created with sketches placed in datum planes with the tools of the PartDesign Workbench
The Surface Workbench integrates with other workbenches of FreeCAD. The above example was created from sketches placed on datum planes in the PartDesign Workbench. The design can be fully parametric, when all datum planes and sketches are defined accordingly. In most cases it is sufficient with drawing a closed sketch to define the border for a face; then options are available to further modify its shape.
The current state of FreeCAD (v0.17) does not allow to place the surfaces into a PartDesign Body. However, the surfaces can be placed inside of a Std Part container together with the PartDesign Body which holds all datum planes and sketches. The non parametric Part Shapebuilder tool must still be used in order to create a shell and a regular solid out of the set of surfaces.
- Filling...: fills a series of boundary curves with a surface. The surface can be modified by adding constraint curves and vertexes. The surface changes its shape so that the surface goes through the added constraint elements.
- Fill boundary curves: creates a surface from two, three or four boundary edges. Three different filling modes are available: Stretch, Coons, Curved.
- Sections: creates a surface from edges that represent transversal sections of surface. introduced in version 0.19
Additional Menu Tools
These tools are only found in the Surface menu.
- Curve on mesh...: A selected mesh from the mesh workbench can serve as a template in order to create manually spline curves on it.
- Extend face: Extrapolate the surface at the boundaries with its local u-parameter and v-parameter.
The used surface code from the CAD-kernel OCCT is very fragile and can not handle wrong input properly. This can cause FreeCAD to crash. The following situations cause problems and may crash FreeCAD:
- adding additional edges or wires as boundary to a surface, that would make up several faces. Add those edges only to Unbound Edges.
- Using of boundary edges, that fails do build a closed boundary at parametric changes of the document.