Spreadsheet Preferences: Difference between revisions

From FreeCAD Documentation
(initial)
 
(finish the page)
Line 14: Line 14:
<translate>
<translate>


The preferences screen of the [[Image:Workbench_Spreadsheet.svg|24px|link=Spreadsheet_Workbench]] [[Spreadsheet_Workbench|Spreadsheetr Workbench]] are found in the [[Preferences_Editor|Preferences Editor]], {{MenuCommand|Edit → Preferences → Spreadsheet}}.
The preferences screen of the [[Image:Workbench_Spreadsheet.svg|24px|link=Spreadsheet_Workbench]] [[Spreadsheet_Workbench|Spreadsheet Workbench]] are found in the [[Preferences_Editor|Preferences Editor]], {{MenuCommand|Edit → Preferences → Spreadsheet}}.


In the preferences you can specify the following:
In the preferences you can specify the following:
Line 22: Line 22:
|-
|-
| {{MenuCommand|Delimiter Character}}
| {{MenuCommand|Delimiter Character}}
| The character that is used as delimiter of the cells when the table is imported or exported.
| If checked, a grid will be shown in the sketches.

This option and the following 5 preferences settings can also be specified only for single sketches in the [[Sketcher_Dialog#Edit_controls|sketcher dialog]] section ''Edit controls''.
|-
|-
| {{MenuCommand|Quote Character}}
| {{MenuCommand|Quote Character}}
| The character used for quotations.
| The distance between two subsequent grid lines. Note that the default value of 0 mm will result in a 10 mm grid.
|-
|-
| {{MenuCommand|Escape Character}}
| {{MenuCommand|Escape Character}}
| The character to tell the parser that the following sequence should not be parsed.
| If checked, new points will snap to the nearest grid line. Note that the points have already to be close to a grid line that the snap takes effect. The distance is a fifth of the value set for {{MenuCommand|Grid size}}, so for a 10 mm grid, the snapping only occurs if the point is not more than 2 mm away from a grid line.
|-
|-
|}
|}

Revision as of 23:15, 2 October 2021

Other languages:

The preferences screen of the Spreadsheet Workbench are found in the Preferences Editor, Edit → Preferences → Spreadsheet.

In the preferences you can specify the following:

Name Description
Delimiter Character The character that is used as delimiter of the cells when the table is imported or exported.
Quote Character The character used for quotations.
Escape Character The character to tell the parser that the following sequence should not be parsed.



Spreadsheet
User documentation
Retrieved from "http://wiki.freecad.org/index.php?title=Spreadsheet_Preferences&oldid=1049702"