Sketcher NewSketch/ro: Difference between revisions

From FreeCAD Documentation
(Created page with "Acest instrument va crea o nouă schiță.")
(Replaced content with "==Utilizare==")
Line 16: Line 16:
Note that the [[PartDesign Workbench|PartDesign workbench]] has its own [[PartDesign NewSketch|new sketch]] command, when using PartDesign it is preferable to use its own dedicated tool.
Note that the [[PartDesign Workbench|PartDesign workbench]] has its own [[PartDesign NewSketch|new sketch]] command, when using PartDesign it is preferable to use its own dedicated tool.


==Utilizare==
<div class="mw-translate-fuzzy">
====Utilizare====
Făcând Click pe iconiță fără nici o fațetă (pre-)selectată va deschide un contextual întrebând în ce plan poate fi creată schița :
* XY-Plane
* XZ-Plane
* YZ-Plane
You can change an offset to any of the three planes and the side of the offset.
</div>


Clicking on the icon without a face (pre-)selected will pop up a dialog asking if the sketch should be drawn on the
Clicking on the icon without a face (pre-)selected will pop up a dialog asking if the sketch should be drawn on the

Revision as of 14:28, 30 March 2019

Creaza schita

poziția meniului
Sketch → Creaza schita
Ateliere
Sketcher
scurtătură
nici unul
Prezentat în versiune
-
A se vedea, de asemenea,
Asociază schiţa unei feţe..., Reorientați schița...

Descriere

Acest instrument va crea o nouă schiță.

Note that the PartDesign workbench has its own new sketch command, when using PartDesign it is preferable to use its own dedicated tool.

Utilizare

Clicking on the icon without a face (pre-)selected will pop up a dialog asking if the sketch should be drawn on the

  • XY-Plane
  • XZ-Plane
  • YZ-Plane

You can change an offset to any of the three planes and the side of the offset.

Clicking on the icon with a (pre-selected) face will cause the sketch to be mapped to the selected face.

Notă

The sketch can be re-mapped to another already existing face using the Map Sketch - Command

The sketch can be re-mapped to another already existing face using the Map Sketch - Command.

The sketch can be moved in the 3D-Space using Placement.