Sketcher NewSketch/it: Difference between revisions
Renatorivo (talk | contribs) (Created page with "Lo schizzo può essere spostato nello spazio 3D utilizzando Posizionamento.") |
Renatorivo (talk | contribs) No edit summary |
||
Line 13: | Line 13: | ||
Clicking on the icon with a (pre-selected) face will cause the sketch to be mapped to the selected face. |
Clicking on the icon with a (pre-selected) face will cause the sketch to be mapped to the selected face. |
||
====Note==== |
==== Note ==== |
||
The sketch can be re-mapped to antoher already existing face. |
|||
Con uno schizzo chiuso si produce una forma piena, un solido. Con uno schizzo aperto si produce una forma vuota, un guscio. |
|||
Lo schizzo può essere rimappato su un'altra faccia esistente. |
|||
Lo schizzo può essere spostato nello spazio 3D utilizzando [[Placement/it|Posizionamento]]. |
Lo schizzo può essere spostato nello spazio 3D utilizzando [[Placement/it|Posizionamento]]. |
Revision as of 21:04, 26 November 2014
Crea Schizzo |
Posizione nel menu |
---|
Part design → Crea uno sketch |
Ambiente |
Sketcher, PartDesign |
Avvio veloce |
Nessuno |
Introdotto nella versione |
- |
Vedere anche |
Mappa schizzo, Riposiziona schizzo |
Description
This will create a new sketch.
Usage
Clicking on the icon without a face (pre-)selected will pop up a dialog asking if the sketch should be drawn on the
- XY-Plane
- XZ-Plane
- YZ-Plane
You can change an offset to any of the three planes and the side of the offset.
Clicking on the icon with a (pre-selected) face will cause the sketch to be mapped to the selected face.
Note
Con uno schizzo chiuso si produce una forma piena, un solido. Con uno schizzo aperto si produce una forma vuota, un guscio.
Lo schizzo può essere rimappato su un'altra faccia esistente.
Lo schizzo può essere spostato nello spazio 3D utilizzando Posizionamento.