Sketcher NewSketch/es: Difference between revisions

From FreeCAD Documentation
(Updating to match new version of source page)
(Updating to match new version of source page)
(2 intermediate revisions by the same user not shown)
Line 9: Line 9:
}}
}}


<div class="mw-translate-fuzzy">
{{GuiCommand/es
{{GuiCommand/es
|Name=Sketcher NewSketch
|Name=Sketcher NewSketch
Line 16: Line 17:
|SeeAlso=[[Sketcher_MapSketch/es|Trazar croquis en cara...]], [[Sketcher_Reorient/es|Reorientar croquis...]]
|SeeAlso=[[Sketcher_MapSketch/es|Trazar croquis en cara...]], [[Sketcher_Reorient/es|Reorientar croquis...]]
}}
}}
</div>


==Descripción==
==Descripción==
Line 51: Line 53:
}}
}}


{{Sketcher Tools navi}}
{{Sketcher Tools navi{{#translation:}}}}
{{PartDesign Tools navi{{#translation:}}}}

{{Userdocnavi}}
{{Userdocnavi{{#translation:}}}}

[[Category:PartDesign/es]]

Revision as of 08:51, 26 September 2020

Crear croquis

Ubicación en el Menú
Sketch → Crear croquis
Entornos de trabajo
Sketcher
Atajo de teclado por defecto
Ninguno
Introducido en versión
-
Ver también
Trazar croquis en cara..., Reorientar croquis...

Descripción

This will create a new sketch.

Note that the PartDesign workbench has its own new sketch command, when using PartDesign it is preferable to use its own dedicated tool.

Utilización

Clicking on the icon without a face (pre-)selected will pop up a dialog asking if the sketch should be drawn on the

  • XY-Plane
  • XZ-Plane
  • YZ-Plane

You can change an offset to any of the three planes and the side of the offset.

Clicking on the icon with a (pre-selected) face will cause the sketch to be mapped to the selected face.

Notas

The sketch can be re-mapped to another already existing face using the Map Sketch - Command.

The sketch can be moved in the 3D view using Placement.