Sketcher NewSketch/es: Difference between revisions

From FreeCAD Documentation
(Updating to match new version of source page)
(Updating to match new version of source page)
Line 30: Line 30:
</div>
</div>


The sketch can be re-mapped to another already existing face using the [[Sketcher MapSketch|Map Sketch - Command]]
The sketch can be re-mapped to another already existing face using the [[Sketcher MapSketch|Map Sketch - Command]].


The sketch can be moved in the 3D-Space using [[Placement]].
The sketch can be moved in the 3D-Space using [[Placement]].

Revision as of 14:08, 30 March 2019

Sketcher NewSketch

Ubicación en el Menú
Croquizador→ Crear croquis
Entornos de trabajo
Croquizador, Diseño de Piezas
Atajo de teclado por defecto
Ninguno
Introducido en versión
-
Ver también
Sketcher MapSketch, Sketcher Reorient

Descripción

This will create a new sketch.

Note that the PartDesign workbench has its own new sketch command, when using PartDesign it is preferable to use its own dedicated tool.

Utilización

Clicking on the icon without a face (pre-)selected will pop up a dialog asking if the sketch should be drawn on the

  • XY-Plane
  • XZ-Plane
  • YZ-Plane

You can change an offset to any of the three planes and the side of the offset.

Clicking on the icon with a (pre-selected) face will cause the sketch to be mapped to the selected face.

Note

The sketch can be re-mapped to another already existing face using the Map Sketch - Command.

The sketch can be moved in the 3D-Space using Placement.