Sketcher CreatePolyline/es

From FreeCAD Documentation
Revision as of 17:21, 20 March 2022 by FuzzyBot (talk | contribs) (Updating to match new version of source page)

Sketcher CreatePolyline

Ubicación en el Menú
Croquizador→ Geometrías del croquizador → Crear polilínea
Entornos de trabajo
Croquizador
Atajo de teclado por defecto
Ninguno
Introducido en versión
-
Ver también
Línea

Descripción

Esta herramienta trabaja como la herramienta Línea, pero crea segmentos de líneas continuos conectados por sus vértices.

Cuando se inicia la herramienta, el puntero del ratón cambia a una cruz blanca con un icono de polilínea rojo. Las coordenadas del puntero se muestran al lado de este en color azul en tiempo real.

Polyline started with a line, a tangent arc, a perpendicular arc then a tangent line.

Utilización

The polyline always starts with a straight line segment: click - move the mouse - click. Move the mouse again. After placing the first line segment, the Sketcher polyline tool has multiple modes that can be toggled with the M key. For example you can draw tangent or perpendicular arcs following a line or arc segment. Repeatedly pressing the M key toggles through these different modes:

  1. Press the M key: the new segment is a line which is perpendicular to the previous segment.
  2. Press the M key again: the new segment is a line which is tangential to the previous segment.
  3. Press the M key again: the new segment is an arc which is tangential to the previous segment.
  4. Press the M key again: the new segment is an arc which is perpendicular (left) to the previous segment.
  5. Press the M key again: the new segment is an arc which is perpendicular(right) to the previous segment.
  6. Press the M key again: You are again in the state where you started; the line is only connected with a coincidence to the previous segment.
  • version 0.18 and above While in any of the arc modes, holding down the Ctrl key (MacOS: CMD key) and moving the cursor causes the arc to snap by increments of 45 degrees, relative to the previously created polyline segment.
  • Pick points on an empty area of the 3D view, or on an existing object (auto constraints must be active in TaskView).
  • Pressing Esc or clicking the right mouse button before closing the polyline to a loop ends the current polyline and you can continue with a new one. Pressing Esc or clicking the right mouse button again ends the polyline function.
  • Pressing Esc or clicking the right mouse button after closing the polyline to a loop ends the polyline function.