Sketcher CreatePoint/cs: Difference between revisions

From FreeCAD Documentation
No edit summary
(Updating to match new version of source page)
Line 24: Line 24:
The created point is not available outside of the sketch. In case a point is needed in the 3D-view, use the [[PartDesign_Point|PartDesign Point]] for a datum point or the [[Part_Point|Part Point]] instead.
The created point is not available outside of the sketch. In case a point is needed in the 3D-view, use the [[PartDesign_Point|PartDesign Point]] for a datum point or the [[Part_Point|Part Point]] instead.
{{clear}}
{{clear}}
[[Category:Sketcher]]

Revision as of 22:54, 25 November 2018

Skicář Bod

Umístění Menu
Náčrt → Skicář Konstrukce → Vytvořit bod
Pracovní stoly
Skicář
Výchozí zástupce
Nikdo
Představen ve verzi
-
Viz také
Nikdo

Popis

Nástroj Point Bod vytvoří bod v aktuálním listu "Skicáře".

Point in the sketcher

Použití

  • Funkci aktivujete stisknutím tlačítka link = Sketcher_Point/cs Bod.
  • Musí být stisknuto tolikrát, kolik bodů chcete vytvořit.
  • Při podržení klávesy Ctrl při kreslení zajistí zachycení bodu k nejbližšímu zachycovacímu bodu, bez ohledu na jeho vzdálenost.
  • Klávesu Esc stiskněte pokud chcete přerušit operaci a ukončit funkci.

Volby

A mode to snap to the grid can be set in the Sketcher Preferences. The point snaps then to the grid, if it has less than 25% grid distance to a grid line. The snap mode does not fix them to the grid. The points can be moved with the mouse or constraints to other locations.

Omezení

The created point is not available outside of the sketch. In case a point is needed in the 3D-view, use the PartDesign Point for a datum point or the Part Point instead.