Sketcher CreatePoint/cs: Difference between revisions
Renatorivo (talk | contribs) (Created page with "* Funkci aktivujete stisknutím tlačítka {{KEY|16px|Point|link = Sketcher_Point/cs Bod}}. * Musí být stisknuto tolikrá...") |
Renatorivo (talk | contribs) (Created page with "==Volby==") |
||
Line 15: | Line 15: | ||
* Klávesu {{KEY|Esc}} stiskněte pokud chcete přerušit operaci a ukončit funkci. |
* Klávesu {{KEY|Esc}} stiskněte pokud chcete přerušit operaci a ukončit funkci. |
||
== |
==Volby== |
||
A mode to snap to the grid can be set in the [[Sketcher_Preferences|Sketcher Preferences]]. The point snaps then to the grid, if it has less than 25% grid distance to a grid line. |
A mode to snap to the grid can be set in the [[Sketcher_Preferences|Sketcher Preferences]]. The point snaps then to the grid, if it has less than 25% grid distance to a grid line. |
Revision as of 21:27, 3 November 2018
Skicář Bod |
Umístění Menu |
---|
Náčrt → Skicář Konstrukce → Vytvořit bod |
Pracovní stoly |
Skicář |
Výchozí zástupce |
Nikdo |
Představen ve verzi |
- |
Viz také |
Nikdo |
Popis
Nástroj Bod vytvoří bod v aktuálním listu "Skicáře".
Použití
- Funkci aktivujete stisknutím tlačítka Bod.
- Musí být stisknuto tolikrát, kolik bodů chcete vytvořit.
- Při podržení klávesy Ctrl při kreslení zajistí zachycení bodu k nejbližšímu zachycovacímu bodu, bez ohledu na jeho vzdálenost.
- Klávesu Esc stiskněte pokud chcete přerušit operaci a ukončit funkci.
Volby
A mode to snap to the grid can be set in the Sketcher Preferences. The point snaps then to the grid, if it has less than 25% grid distance to a grid line. The snap mode does not fix them to the grid. The points can be moved with the mouse or constraints to other locations.
Limitations
The created point is not available outside of the sketch. In case a point is needed in the 3D-view, use the PartDesign Point for a datum point or the Part Point instead.