Sketcher Ellipse par son centre
Sketcher CreateEllipse |
Emplacement du menu |
---|
Sketch → Sketcher geometries → Create ellipse by center |
Ateliers |
Sketcher, Part Design |
Raccourci par défaut |
Aucun |
Introduit dans la version |
- |
Voir aussi |
Sketcher Ellipse by 3 Points, Sketcher Circle, Sketcher Arc of Ellipse |
Description
This tool draws an ellipse by picking three points: the center, the end of major radius, the minor radius. When starting the tool, the mouse pointer changes to a white cross with a red ellipse icon. Besides are coordinates shown in real time.
Utilisation
- Cliquer sur le bouton de la barre d'outils, en choisissant l'élément de menu, ou en utilisant le raccourci clavier (il faut d'abord attribuer la touche dans Personnalisation de l'interface).
- Le premier clic dans la vue 3D, définit le centre de l'ellipse. Le deuxième clic définit le premier rayon et l'orientation de l'ellipse. Le troisième clic définit l'autre rayon (la distance de la ligne définie par les deux premiers clics est le deuxième rayon).
- Après le troisième clic, l'ellipse est créée, ainsi qu'un ensemble de géométrie de construction aligné (diamètre principal, diamètre mineur, deux centre). La géométrie de la construction peut être supprimée manuellement si elle n'est pas nécessaire et recréée ultérieurement. Voir Internal Alignment Constraint et Sketcher Show Hide Internal Geometry.
- En appuyant sur ESC ou en cliquant sur le bouton droit de la souris, vous annulez la fonction.
Peculiarities
- Major and minor axes of ellipses are strict and cannot be swapped by resizing the ellipse. This is a consequence of the solver parametrization used (center (x,y), focus1 (x,y) and minor radius length (b)) and the same strict behavior of OpenCascade. The ellipse must be rotated to swap the axes.
- Ellipse can function as a circle when its major and minor diameter lines are deleted, and one of the foci is constrained to coincide with the center. But radius constraint won't work on such a circle.
- Moving the ellipse by edge is the same as moving ellipse's center.
Version
Introduced in FreeCAD v0.15.4309