Sketcher HyperbelbogenErstellen

From FreeCAD Documentation
Revision as of 19:42, 29 March 2020 by FuzzyBot (talk | contribs) (Updating to match new version of source page)

Sketcher Hyperbel erstellen

Menüeintrag
Sketch → Skizzengeometrien → Bogen einer Hyperbel erstellen
Arbeitsbereich
Sketcher
Standardtastenkürzel
Keiner
Eingeführt in Version
0.17
Siehe auch
Sketcher Ellipsen-Bogens, Sketcher Bogen der Parabel

Beschreibung

This tool creates an arc of hyperbola by center, major radius and endpoints.

Anwendung

  1. Press the Create an arc of hyperbola button.
  2. Click in the 3D view to define the major radius center (labelled 1 in the picture above).
  3. Click in the 3D view to define the major radius length, which is also the tip of the arc of hyperbola (labelled 2 in the picture above).
  4. Move the mouse away from the two last selected points to see how the arc will look like. Click again when the approximate desired curvature is shown. This point will define the first end point (labelled 3 in the picture above).
  5. Click a fourth time in the 3D view to define the other end point (labelled 4 in the picture above).