Sketcher CreateArcOfEllipse/it: Difference between revisions

From FreeCAD Documentation
(Created page with "====Descrizione==== Questo strumento disegna un arco di ellisse selezionando quattro punti: il centro, la fine del raggio maggiore, il punto iniziale e il punto finale dell'ar...")
(Created page with "[[Image:Sketcher_ArcOfEllipseExample1.png‎|thumb|none|500px|La sequenza della selezione è indicata dalle frecce gialle con i numeri. C è il centro, a è il diametro maggio...")
Line 5: Line 5:
Quando si avvia lo strumento, il puntatore del mouse si trasforma in una croce bianca con un'icona a forma di ellisse rossa. Le coordinate sono indicate in tempo reale.
Quando si avvia lo strumento, il puntatore del mouse si trasforma in una croce bianca con un'icona a forma di ellisse rossa. Le coordinate sono indicate in tempo reale.


[[Image:Sketcher_ArcOfEllipseExample1.png‎|thumb|none|500px|The sequence of clicks is indicated by yellow arrows with numbers. C is the center, a - major diameter, b - minor diameter, F1, F2 are foci.]]
[[Image:Sketcher_ArcOfEllipseExample1.png‎|thumb|none|500px|La sequenza della selezione è indicata dalle frecce gialle con i numeri. C è il centro, a è il diametro maggiore, b è il diametro minore, F1 e F2 sono i fuochi.]]


====Usage====
====Usage====

Revision as of 18:37, 24 December 2014

Arco di ellisse

Posizione nel menu
Sketch → Geometrie → Crea un arco di ellisse
Ambiente
Sketcher, Part Design
Avvio veloce
Nessuno
Introdotto nella versione
-
Vedere anche
Ellisse, Arco

Descrizione

Questo strumento disegna un arco di ellisse selezionando quattro punti: il centro, la fine del raggio maggiore, il punto iniziale e il punto finale dell'arco. Quando si avvia lo strumento, il puntatore del mouse si trasforma in una croce bianca con un'icona a forma di ellisse rossa. Le coordinate sono indicate in tempo reale.

La sequenza della selezione è indicata dalle frecce gialle con i numeri. C è il centro, a è il diametro maggiore, b è il diametro minore, F1 e F2 sono i fuochi.

Usage

  • Invoke the command by clicking a toolbar button, picking the menu item, or by using keyboard shortcut (needs to be assigned first in Interface Customization).
  • First click in 3D view sets ellipse center. Second click sets the first radius and orientation of the ellipse. Third click sets the other radius and the start of the arc. The fourth click sets the end of the arc.
  • After the fourth click, the arc of ellipse is created, together with a set of construction geometry aligned to it (major diameter, minor diameter, two foci). The construction geometry can be manually deleted if not needed, and recreated later. See Internal Alignment Constraint and Sketcher Show Hide Internal Geometry.
  • Pressing ESC or clicking the right mouse button cancels the function.

Peculiarities

  • Major and minor axes of underlying ellipse are strict and cannot be swapped by resizing. The underlying ellipse must be rotated to swap the axes.
  • Unlike ellipse that can be constrained to become a circle, ellipse arc cannot represent an arc of circle.
  • Moving the arc of ellipse by edge is the same as moving ellipse's center.

Version

Introduced in FreeCAD v0.15.4309