Constraint PointOnPoint
Constraint PointOnPoint |
Ubicación en el Menú |
---|
Croquizador → Restricciones del Croquizador → Coincidente |
Entornos de trabajo |
Croquizador, Diseño de Piezas |
Atajo de teclado por defecto |
Ninguno |
Introducido en versión |
- |
Ver también |
Bloquear, Punto en objeto |
"Create a coincident constraint on the selected item"
Description
This constraint tool takes two points as its argument and serves to make the two points coincident. (Meaning to make them as-one-point). In practical terms this constraint tool is useful when there is a break in a profile for example - where two lines end near each other and need to be joined - a coincident constraint on their end-points will close the gap.
Usage
As stated above, this tool takes two arguments - both are points.
- Firstly it is necessary to highlight two distinct points. (Note this will not work if, for example, you attempt to select the start and end point of the same line).
- Highlighting of a drawing item is achieved by moving the mouse over the item and clicking the left-mouse-button.
- A highlighted item will change colour to green.
- Subsequent items can be highlighted by repeating the above procedure(s) NOTE: There is no-need to hold-down any special key like Ctrl to achieve multiple item selection in a drawing.
- Once you have two points highlighted, left-clicking on the 'PointOnPoint' constraint will cause the two points to become coincident and be replaced by a single point.
NOTE: In order to make two points coincident, FreeCAD must necessarily move one, or both, of the original points.