Sketcher ConstrainCoincident/es: Difference between revisions
Renatorivo (talk | contribs) (Created page with ""Crea una restricción de coincidencia en los objetos seleccionados" ==Descripción== Esta restricción permite hacer dos puntos <em>coincidentes</em>.") |
Renatorivo (talk | contribs) (Created page with "==Utilización== #Selecciona dos puntos. #Selecciona la restricción 'Coincidencia' y los dos puntos pasarán a ser coincidentes.") |
||
Line 7: | Line 7: | ||
Esta restricción permite hacer dos puntos <em>coincidentes</em>. |
Esta restricción permite hacer dos puntos <em>coincidentes</em>. |
||
== |
==Utilización== |
||
As stated above, this tool takes two arguments - both are points. |
|||
#Selecciona dos puntos. |
|||
#Firstly it is necessary to highlight two distinct points. (Note this will not work if, for example, you attempt to select the start and end point of the same line). |
|||
#Selecciona la restricción 'Coincidencia' y los dos puntos pasarán a ser coincidentes. |
|||
#Highlighting of a drawing item is achieved by moving the mouse over the item and clicking the left-mouse-button. |
|||
#A highlighted item will change colour to green. |
|||
#Subsequent items can be highlighted by repeating the above procedure(s) NOTE: There is no-need to hold-down any special key like Ctrl to achieve multiple item selection in a drawing. |
|||
#Once you have two points highlighted, left-clicking on the 'PointOnPoint' constraint will cause the two points to become ''coincident'' and be replaced by a single point. |
|||
NOTE: In order to make two points coincident, FreeCAD must necessarily move one, or both, of the original points. |
|||
{{clear}} |
{{clear}} |
Revision as of 21:09, 18 December 2013
Constraint PointOnPoint |
Ubicación en el Menú |
---|
Croquizador → Restricciones del Croquizador → Coincidente |
Entornos de trabajo |
Croquizador, Diseño de Piezas |
Atajo de teclado por defecto |
Ninguno |
Introducido en versión |
- |
Ver también |
Bloquear, Punto en objeto |
"Crea una restricción de coincidencia en los objetos seleccionados"
Descripción
Esta restricción permite hacer dos puntos coincidentes.
Utilización
- Selecciona dos puntos.
- Selecciona la restricción 'Coincidencia' y los dos puntos pasarán a ser coincidentes.