CAM Contrôleur d'outil
This documentation is not finished. Please help and contribute documentation.
GuiCommand model explains how commands should be documented. Browse Category:UnfinishedDocu to see more incomplete pages like this one. See Category:Command Reference for all commands.
See WikiPages to learn about editing the wiki pages, and go to Help FreeCAD to learn about other ways in which you can contribute.
Un contrôleur d'outil porte des propriétés sur la manière dont un outil doit être utilisé dans une ou plusieurs opérations.
For example a tool, like a 1/4 inch cutter can run at many different spindle speeds and feed rates. The same tool might be used in different ways in the same job.
properties:
feed speed (h) feed speed (v)
rapid speed (h) rapid speed (v)
Spindle Speed (rpm) Spindle direction (forward/reverse)
Tool Number