Path Cavidade Shape

From FreeCAD Documentation
Revision as of 08:40, 4 June 2018 by FuzzyBot (talk | contribs) (Updating to match new version of source page)

Path Pocket

Localização do menu
Path → Nova operação → Cavidade
Bancadas de trabalho
Path
Atalho padrão
P,O
Introduzido na versão
-
Veja também
Nenhum

Description

This tool creates a pocketing operation from selected bottom faces or walls of one ore more pockets of the jobs base object.

The Path Pocket object is made to be part of a Path Job.

Usage

  1. Select the bottom or the wall(s) of a pocket. While it is usually easier to select the bottom, the walls have to be selected when a pocket goes through all.
  2. Press the Pocket Shape button
  3. Adjust the desired properties

Properties

Base Geometry

  • Add, if not allready done, the elements which should be the base for the path
    • you can also delete or change to other elements

Depth

  • DadosStart Depth: Starting Depth of Tool- starting depth in Z
  • DadosFinal Depth: Final Depth of Tool- lowest cutting level in Z
  • DadosFinish Depth: The hight of the last cutting level- set for a better finish
  • DadosStep Down: Step Down of Tool- the amount of material which will be removed at once

Height

  • DadosSafe Height: The hight above the workpeace where rapid motions are allowed.
  • DadosClearance Height: The height needed to clear clamps and obstructions

Operation

  • DadosTool Controller: Defines the Tool controller used in the Operation
  • DadosCut Mode: Specifies a CW or CCW move for the cut
  • DadosPattern: Select on which manner the horizontal movements should be done
  • DadosAngle: Select the path angle relativ to x axis
  • DadosStep Over Percent: Select the horizontal step over- 100% = tool diameter
  • DadosPass Extension:


Other languages: