Part Tore

From FreeCAD Documentation
Revision as of 08:19, 13 March 2019 by Jpg87 (talk | contribs)

Tore

Emplacement du menu
Pièce → Tore
Ateliers
Atelier Pièce
Raccourci par défaut
Aucun
Introduit dans la version
-
Voir aussi
Créer des Primitives

Description

Crée un tore paramétrique simple, avec les paramètres position, angle1, angle2, angle3, rayon1 et rayon2.

How to use

In the Part workbench click on the torus icon . The torus will be positioned at origin (point 0,0,0) on creation. The angle parameters (angle1, angle2, angle3), as well as the radius parameter (radius1 , radius2) parameters permit to parametrize the torus, see next paragraph.

Option

Parameter

A torus can be assimilated to a small disc that makes a circular orbit around an imaginary axe. Thus the parametric torus is defined by the following parameters:

  • Radius1: Radius of the circle around which the disc circulate
  • Radius2: Radius of the disc defining the form of the torus
  • Angle1: 1st angle to cut / define the disc of the torus
  • Angle2: 2nd angle to cut / define the disc of the torus
  • Angle3: 3rd angle to define the circumference of the torus.

as well as the standard set of placement parameters. The pictures below give a visual overview of the parameters antecedently mentioned:

The parameter Radius1 has a value of 20 mm.

The parameter Radius2 has a value of 2 mm.

The parameter Angle1 has a value of -90°. Notice that, the "angle measure" tool cannot display negative angle. Considered the displayed value in picture as "-90°".

The parameter Angle2 has a value of 90°.

The parameter Angle3 has a value of 90°.