Część: Sfera

From FreeCAD Documentation
Revision as of 22:43, 11 February 2021 by FuzzyBot (talk | contribs) (Updating to match new version of source page)

Part: Kula

Lokalizacja w menu
Część → Bryła pierwotna → Kula
Środowisko pracy
Part
Domyślny skrót
brak
Wprowadzono w wersji
-
Zobacz także
Part: Bryły pierwotne

Description

Creates a simple parametric sphere, with position, angle1, angle2, angle3 and radius parameters.

Usage

  1. Switch to the Part Workbench
  2. There are several ways to invoke the command:
    • Press the button in the toolbar.
    • Select the Part → Primitives → Sphere from the menu bar.


Result: The sphere will be positioned at origin (point 0,0,0) on creation. The angle parameters permit to make a portion of sphere instead of a full sphere (they are set to 360° by default).

Options

The parametric sphere is defined by the following parameters:

  • Radius
  • Angle 1
  • Angle 2
  • Angle 3
  • as well as the standard set of placement parameters

The picture below gives an overview of a parametric sphere with parameters different from the default value.

Parameter

  • DANERadius: Radius of the sphere
  • DANEAngle 1: 1nd angle to cut / define the sphere
  • DANEAngle 2: 2nd angle to cut / define the sphere
  • DANEAngle 3: 3rd angle to cut / define the sphere

Because it is quite difficult to explain the meaning of the parameters angle 1, angle 2, angle 3, the picture below gives an explanation about these parameters with following values: angle 1 = -45°, angle 2 = 45° and angle 3= 90°.