Part Sphere/cs: Difference between revisions
(Updating to match new version of source page) |
(Updating to match new version of source page) |
||
Line 1: | Line 1: | ||
<languages/> |
|||
{{GuiCommand/cs|Name=Part Sphere|Name/cs=Díl Koule|MenuLocation=Díl -> Koule||Workbenches=[[Part_Module/cs|Modul Díl]], Kompletace|SeeAlso=[[Part_CreatePrimitives/cs|Díl Vytváření zákl.geom.tvarů]]}} |
{{GuiCommand/cs|Name=Part Sphere|Name/cs=Díl Koule|MenuLocation=Díl -> Koule||Workbenches=[[Part_Module/cs|Modul Díl]], Kompletace|SeeAlso=[[Part_CreatePrimitives/cs|Díl Vytváření zákl.geom.tvarů]]}} |
||
Vytvoří jednoduchou parametrickou kouli podle parametrů pozice, úhel1, úhel2, úhel3 a poloměr. |
Vytvoří jednoduchou parametrickou kouli podle parametrů pozice, úhel1, úhel2, úhel3 a poloměr. |
||
== |
== How to use == |
||
In the workbench [[Part_Workbench|Part]] click on the sphere icon [[Image:Part Sphere.png|32px]]. The sphere will be positioned at origin (point 0,0,0) on creation. The angle parameters permit to make a portion of sphere instead of a full sphere (they are set to 360° by default). |
|||
V pracovní ploše [[Part_Workbench/cs|Díl]] klikněte na ikonu koule [[Image:Part Sphere.png|32px]]. |
|||
Koule bude při vytvoření umístěna do počátečního bodu (bod 0,0,0). Parametry úhly dovolují vytvořit částečnou kouli místo celé koule (defaultně jsou nastaveny na 360°) |
|||
== Volby == |
== Volby == |
Revision as of 12:15, 29 November 2014
Díl Koule |
Umístění Menu |
---|
Díl -> Koule |
Pracovní stoly |
Modul Díl, Kompletace |
Výchozí zástupce |
Nikdo |
Představen ve verzi |
- |
Viz také |
Díl Vytváření zákl.geom.tvarů |
Vytvoří jednoduchou parametrickou kouli podle parametrů pozice, úhel1, úhel2, úhel3 a poloměr.
How to use
In the workbench Part click on the sphere icon . The sphere will be positioned at origin (point 0,0,0) on creation. The angle parameters permit to make a portion of sphere instead of a full sphere (they are set to 360° by default).
Volby
The parametric sphere is defined by the following parameters:
- Radius
- Angle 1
- Angle 2
- Angle 3
- as well as the standard set of placement parameters
The picture below gives an overview of a parametric sphere with parameters different from the default value.
Parameter
- Radius: Radius of the sphere
- Angle 1: Angle defined between the y-axis (green arrow) and an imaginary rotating line around the x-axis (red arrow). One end of the line is fixed on the origin. The other end of the line may rotate as said around the x-axis and remain in the XY-plane. The line has the length of the radius of the sphere.
- Angle 2: Test