Part: Ellisse
Ellisse |
Posizione nel menu |
---|
Parte → Crea primitive → Ellisse |
Ambiente |
Parte, OpenSCAD |
Avvio veloce |
Nessuno |
Introdotto nella versione |
- |
Vedere anche |
.. |
Crea una ellisse o un settore di ellisse parametrico.
Utilizzare il menu Template:KEY/it. Si apre una finestra di dialogo che consente di impostare:
Primitive Geometriche
Al dialogo Create Primitives si accede tramite l'icona CreatePrimitives situata nel menu Part o tramite la barra degli strumenti Parte, nell'ambiente Parte.
This command will create a elliptical curved edge. With the default values, the elliptical curved edge will be closed and therefore will be an ellipse. If the properties Angle 1 or Angle 2 are changed from their default values (0 and 360) the edge will be an open curve.
Properties
- Major radius: the major radius of the ellipse, the default value is 4
- Minor radius: the minor radius of the ellipse, the default value is 2
- Angle 1: start of the edge of the ellipse or elliptical curved edge, (degrees anti-clockwise), the default value is 0
- Angle 2: end of the edge of the ellipse or elliptical curved edge, (degrees anti-clockwise), the default value is 360