Part Cone/sv: Difference between revisions

From FreeCAD Documentation
(Updating to match new version of source page)
(Created page with "{{GuiCommand/sv|Name=Part_Cone|Workbenches=Del,Komplett}}")
Line 1: Line 1:
{{GuiCommand|Name=Part_Cone|MenuLocation=Part -> Cone||Workbenches=[[Part_Module|Part]],Complete|SeeAlso=[[Part_CreatePrimitives|Part_CreatePrimitives]]}}
{{GuiCommand/sv|Name=Part_Cone|Workbenches=Del,Komplett}}


Creates a simple parametric cone, with position, angle, radius1, radius2 and height parameters. The cone will be positioned at origin (point 0,0,0) on creation. The angle parameter permits the creation of a portion of cone (it is set to 360° by default), and the radius 1 and 2 correspond to base and top radius of the cone.
Creates a simple parametric cone, with position, angle, radius1, radius2 and height parameters. The cone will be positioned at origin (point 0,0,0) on creation. The angle parameter permits the creation of a portion of cone (it is set to 360° by default), and the radius 1 and 2 correspond to base and top radius of the cone.

Revision as of 17:40, 20 February 2014

Part_Cone

Menyplacering
Ingen
Arbetsbänkar
Del,Komplett
Standard genväg
Ingen
Introducerad i version
-
Se även
Ingen

Creates a simple parametric cone, with position, angle, radius1, radius2 and height parameters. The cone will be positioned at origin (point 0,0,0) on creation. The angle parameter permits the creation of a portion of cone (it is set to 360° by default), and the radius 1 and 2 correspond to base and top radius of the cone.