Part Проверка геометрии
Part CheckGeometry |
Системное название |
---|
Part CheckGeometry |
Расположение в меню |
Деталь → Проверка геометрии |
Верстаки |
Part |
Быстрые клавиши |
Нет |
Представлено в версии |
- |
См. также |
Нет |
Описание
Введение
Инструмент проверки геометрии позволяет убедиться, что тело не содержит ошибок.
Применение
- Select a part (beware to select the whole part and not just a face to check for valid solid)
- Invoke the tool by either:
- Clicking on the CheckGeometry button available in the Part workbench toolbar.
- Using the Part → Check geometry entry from the top menu.
- The Settings task panel opens, unless Skip settings page is enabled. See Options for more information. Click Run check.
Results will be reported in the Task panel. If the check produced errors: click in the report on a specific error message and the corresponding geometric object (edge, face, etc.) will be highlighted in the 3D view.
Note: FreeCAD has no automatic repair methods for solids, so you need to look at the steps involved to model this specific geometry and try to fix the error on your own.
Options
Skip settings page
If ticked, subsequent invocations of the tool skip showing the Settings task panel.
Run BOP check
If ticked, additionally a Boolean OPerations (BOP) check is performed. introduced in version 0.19
Log errors
If ticked, any errors found are also logged in the report view. introduced in version 0.19
- Примитивы: Куб(Параллелограмм), Конус, Цилиндр, Сфера, Тор, Полый цилиндр,Примитивы, Связующие формы
- Создание и правка: Выдавливание, Построение фигуры вращения, Отражение, Скругление, Фаска, Создать плоскость из граней, Ruled Surface, Профиль, Sweep, Section, Cross sections, 3D Offset, 2D Offset, Создать полый объект, Projection on surface, Прикрепление
- Булевы операции: Соединить, Разорвать связь, Compound Filter, Булевы операции, Cut, Fuse, Common, Connect, Embed, Cutout, Boolean fragments, Slice apart, Slice, XOR
- Измерительные: Measure Linear, Measure Angular, Measure Refresh, Clear All, Toggle All, Toggle 3D, Toggle Delta
- Начинающим
- Установка: Загрузка, Windows, Linux, Mac, Дополнительных компонентов, Docker, AppImage, Ubuntu Snap
- Базовая: О FreeCAD, Интерфейс, Навигация мыши, Методы выделения, Имя объекта, Настройки, Верстаки, Структура документа, Свойства, Помоги FreeCAD, Пожертвования
- Помощь: Учебники, Видео учебники
- Верстаки: Std Base, Arch, Assembly, CAM, Draft, FEM, Inspection, Mesh, OpenSCAD, Part, PartDesign, Points, Reverse Engineering, Robot, Sketcher, Spreadsheet, Start, Surface, TechDraw, Test Framework, Web