Part CheckGeometry/it: Difference between revisions

From FreeCAD Documentation
No edit summary
(Updating to match new version of source page)
Line 6: Line 6:
==Utilizzo==
==Utilizzo==


The tool is available in the Part workbench under Part menu or with the button in the Boolean toolbar.
Per attivare i controlli BOP supplementari, andare nel menu Strumenti -> Modifica parametri ... poi navigare come nella schermata sottostante
Select a part (beware to select the whole part and not just a face to check for valid solid) then launch the tool.
You will see results in the Task panel.


Dall'ambiente Part o da Part Design
Dall'ambiente Part o da Part Design
Line 12: Line 14:
Strumenti > Modifica parametri > Preferenze > Mod > Part > CheckGeometry
Strumenti > Modifica parametri > Preferenze > Mod > Part > CheckGeometry
quindi nel riquadro di destra fare doppio clic sotto Valore per il parametro RunBOPCheck e impostarlo '''true''' poi cliccare su "Salva su disco", chiudere e riavviare.
quindi nel riquadro di destra fare doppio clic sotto Valore per il parametro RunBOPCheck e impostarlo '''true''' poi cliccare su "Salva su disco", chiudere e riavviare.

If you want to enable the extra BOP checks then follow these steps :
Tools menu > Edit Parameters > Preferences > Mod > Part > CheckGeometry
then in the right pane double click under Value for the RunBOPCheck parameter and set to true, then click Save to disk, close and restart.
See the screenshot below.

If the parameter or folder does not exist, you can create it with a right click.





Revision as of 20:07, 11 April 2016

Controlla geometria‏‎

Posizione nel menu
Part → Controlla geometria
Ambiente
Part
Avvio veloce
Nessuno
Introdotto nella versione
-
Vedere anche
Nessuno

Introduzione

Lo strumento di controllo della geometria consente di verificare se si dispone di un solido valido

Utilizzo

The tool is available in the Part workbench under Part menu or with the button in the Boolean toolbar. Select a part (beware to select the whole part and not just a face to check for valid solid) then launch the tool. You will see results in the Task panel.

Dall'ambiente Part o da Part Design

Strumenti > Modifica parametri > Preferenze > Mod > Part > CheckGeometry quindi nel riquadro di destra fare doppio clic sotto Valore per il parametro RunBOPCheck e impostarlo true poi cliccare su "Salva su disco", chiudere e riavviare.

If you want to enable the extra BOP checks then follow these steps : Tools menu > Edit Parameters > Preferences > Mod > Part > CheckGeometry then in the right pane double click under Value for the RunBOPCheck parameter and set to true, then click Save to disk, close and restart. See the screenshot below.

If the parameter or folder does not exist, you can create it with a right click.


File:PartCheckGeometry.png