Part CheckGeometry/it: Difference between revisions
(Updating to match new version of source page) |
Renatorivo (talk | contribs) (Created page with "Dall'ambiente Part o da Part Design Strumenti > Modifica parametri > Preferenze > Mod > Part > CheckGeometry quindi nel riquadro di destra fare doppio clic sotto Valore per...") |
||
Line 5: | Line 5: | ||
==Utilizzo== |
==Utilizzo== |
||
If you want to enable the extra BOP checks then go to the Tools menu ... edit parameters...then navigate as per this screen shot below |
|||
Dall'ambiente Part o da Part Design |
Dall'ambiente Part o da Part Design |
||
Strumenti > Modifica parametri > Preferenze > Mod > Part > CheckGeometry |
Strumenti > Modifica parametri > Preferenze > Mod > Part > CheckGeometry |
||
quindi nel riquadro di destra fare doppio clic sotto Valore per il parametro RunBOPCheck e impostarlo '''true''' poi cliccare su "Salva su disco" |
quindi nel riquadro di destra fare doppio clic sotto Valore per il parametro RunBOPCheck e impostarlo '''true''' poi cliccare su "Salva su disco", chiudere e riavviare. |
||
From the Part or Part Design WB |
|||
Tools > Edit Parameters > Preferences > Mod > Part > CheckGeometry |
|||
then in the right pane double click under Value for the RunBOPCheck parameter and set to true, then click Save to disk, close and restart. |
|||
Revision as of 18:25, 12 December 2015
Controlla geometria |
Posizione nel menu |
---|
Part → Controlla geometria |
Ambiente |
Part |
Avvio veloce |
Nessuno |
Introdotto nella versione |
- |
Vedere anche |
Nessuno |
Introduzione
Lo strumento di controllo della geometria consente di verificare se si dispone di un solido valido
Utilizzo
If you want to enable the extra BOP checks then go to the Tools menu ... edit parameters...then navigate as per this screen shot below
Dall'ambiente Part o da Part Design
Strumenti > Modifica parametri > Preferenze > Mod > Part > CheckGeometry quindi nel riquadro di destra fare doppio clic sotto Valore per il parametro RunBOPCheck e impostarlo true poi cliccare su "Salva su disco", chiudere e riavviare.