PartDesign: Pocket

From FreeCAD Documentation
Revision as of 21:51, 25 March 2020 by FuzzyBot (talk | contribs) (Updating to match new version of source page)

PartDesign Pocket

Menu location
PartDesign → Pocket
Workbenches
PartDesign, Complete
Default shortcut
None
Introduced in version
-
See also
None

Descriere

Instrumentul Pocket așchiază un solid prin extrudarea unei schițe în traiectorie dreaptă și extrăgând-o din solid.

Sketch profile (A) was mapped to the top face of base solid (B); result after pocketing through on the right.

Cum se foloseșste

  1. Select the sketch to be pocketed.
    v0.16 and below The sketch must be mapped to the planar face of an existing solid or Part Design feature, or an error message will appear.
  2. Press the Pocket button.
  3. Set the Pocket parameters (see next section).
  4. Click OK.

Opțiuni

Atunci când se creează un pocket, dialogul Pocket parameters oferă cinci căi diferite de specificare a lungimii(adâncimii) la care buzunarul va fi extrudat:

Dimension

Enter a numeric value for the depth of the pocket. The default direction for extrusion is into the support. Extrusions occur normal to the defining sketch plane. Negative dimensions are not possible. Use the Reversed option instead.

To first

The pocket will extrude up to the first face of the support in the extrusion direction. In other words, it will cut through all material until it reaches an empty space.

Through all

The pocket will cut through all material in the extrusion direction. With the option Symmetric to plane the pad will cut through all material in both directions.

Up to face

The pocket will extrude up to a face in the support that can be chosen by clicking on it.

Two dimensions

v0.17 and above This allows to enter a second length in which the pad should extend in the opposite direction (into the support). Again can be changed by ticking the Reversed option.

Limitări

  • Use the type Dimension or Through All wherever possible because the other types sometimes give trouble when they are being patterned
  • Otherwise, the pocket feature has the same limitations as the pad feature.

Link uri utile

Un exemplu example are partea practică pe forum.