Part Design: Scanalatura

From FreeCAD Documentation
Revision as of 06:50, 18 March 2018 by Normandc (talk | contribs) (Created page with "===Angolo===")

Scanalatura

Posizione nel menu
PartDesign → Scanalatura
Ambiente
PartDesign, Completo
Avvio veloce
Nessuno
Introdotto nella versione
-
Vedere anche
Rivoluzione

Descrizione

Questo strumento rivoluziona uno schizzo selezionato o un oggetto 2D attorno ad un dato asse, asportando del materiale dall'oggetto di supporto.

Above: sketch (A) is revolved around axis (B); resulting groove on solid (C) is shown right.

Utilizzo

  1. Selezionare uno schizzo mappato su una faccia o un oggetto 2D
  2. Fare clic su Template:KEY/it.

Opzioni

Quando si crea una scanalatura, la finestra di dialogo Parametri Groove offre diversi parametri per specificare come deve essere ruotato il disegno. I parametri di Scanalatura hanno esattamente lo stesso significato che hanno per la funzione di rivoluzione.

Assi

Questa opzione specifica l'asse intorno al quale il disegno deve essere ruotato. Attualmente, in questa finestra, si può selezionare solo l'asse schizzo orizzontale o verticale.

Angolo

This controls the angle through which the groove is to be formed, e.g. 360° would be a full, contiguous revolution. It is not possible to specify negative angles (use the Reversed option instead) or angles greater than 360° .

Symmetric to plane

If checked, the groove will extend half of the specified angle in both directions from the sketch plane .

Reversed

If checked, the direction of revolution is reversed from default clockwise to counterclockwise .

Properties

Below are properties which can be defined after creation of the feature. Data properties Base and Axis are uneditable .

  • DatiAngle: angle of rotation. See Angle .
  • DatiLabel: label given to the operation, can be changed at convenience.
  • DatiMidplane: true or false. See Symmetric to plane.
  • DatiReversed: true or false. See Reversed.
  • DatiRefine: v0.17 and above true or false. If set to true, cleans the solid from residual edges left by features. See Part RefineShape for more details.