Measurement Of Angles On Holes

Introduction

By creating angles for holes it's not possible to use vertical or horizontal center lines (false/true) from the properties of the view. Helping lines and/or helping points are necessary for creating.

Proceeding:

1.Setting center lines on holes:

There are some possibilities to create a center line for holes. At first the lines or points on the hole must be selected as shown below. Behind them the tool File:AnHi4.PNG or File:AnHi6.PNG from the tool bar is creating the center line.

File:AnHi3.PNG

create center line by point - point

File:AnHi5.PNG

create center line by line - line