FEM tutorial

From FreeCAD Documentation
Revision as of 06:26, 6 March 2016 by Drei (talk | contribs) (Updated tutorial to current workflow.)

{{TutorialInfo Topic= Finite Element Analysis |Level= Beginner |Time= 10 minutes + Solver time |Author=Drei |FCVersion=0.16 or above |Files= }}

Introduction

This tutorial is meant to introduce the reader to the basic workflow of the FEM Workbench, as well as most of the tools that are available to perform a static analysis.

Requirements

  • FreeCAD version 0.16 or above
  • Netgen and/or GMSH is installed on the system
  • In the case of GMSH, installation of psicofil's macro is recommended
  • Calculix is installed on the system
  • The reader has the basic knowledge to use the Part and PartDesign Workbenches

Procedure

Modeling

In this example a Cube is used as the study object, but models created in the Part or PartDesign Workbenches can be used instead.

  1. Create a new document
  2. Activate the Part Workbench
  3. Create a Cube
  4. Change its Dimensions to the following:
    1. Height: 1.000 mm
    2. Length: 8.000 mm
    3. Width: 1.000 mm

Now we have a model with which to work with.

Creating the Analysis

Netgen
  1. Select the model
  2. Select File:Fem FemMesh.svg Create FEM mesh
  3. Click Ok
  4. Select the Mesh from the Tree View
  5. Click New mechanical analysis from the menu to create an analysis from the mesh that was created

You can also drag and drop a mesh to a Mechanical Analysis that does not have a mesh within the Tree View.

GMSH

The usage of psicofil's macro is recommended, and is used for this example.

  1. Activate the macro
  2. Select the object you wish to use, in this case our Cube
  3. Check the box Create Mechanical Analysis from mesh
  4. Click OK

We have now meshed our object and are ready to add constraints and forces.

Constraints and Forces

  1. Hide the mesh from the Tree View.
  2. Show the original model
  3. Select Create FEM fixed constraint
  4. Select the back face of the Cube (face on the YZ axis) and click OK
  5. Select Create FEM force constraint
  6. Select the front face of the Cube (the face parallel to the back face) and set the Area load value to 9000000.00
  7. Set the Direction to -Z by selecting one of the face edges parallel to that direction.
  8. Click OK

We now have established the restrictions and forces for our static study.

Final preparations

  1. Select File:Fem Material.svg Mechanical material... and choose Calculix as the material
  2. Click OK

Running the Solver

Standard Procedure
  1. Select the solver object contained in the Mechanical Analysis
  2. Select File:Fem NewAnalysis.svg Start calculation from the menu
  3. Select Write Calculix Input File
  4. Select Run Calculix
  5. Click Close
Quick Procedure
  1. Click on File:Fem QuickAnalysis.svg Quick Analysis.

Analyzing Results

  1. From the Object Tree, select the Results object
  2. Select File:Fem Result.svg Show result
  3. Choose among the different Result types to view the results
  4. The slider at the bottom can be used to alter the mesh visualization. This allows us to visualize the deformation experienced by the object, keep in mind that this is an approximation.
  5. To remove the results select File:Fem PurgeResults.png Purge results
Comparison to previous example file

If you select the Z diplacement result type, you can see that the obtained value is almos identical to the test example provided by FreeCAD. Differences may occur due to the quality of the mesh and the number of nodes it possesses.

}

We are now finished with the basic workflow for the FEM Module.