FEM CalculiX
Preface
This page collects all informations about the current solver used by FreeCAD's FEM Module. The interface between the solver and FreeCAD in pre- as well as post processing is also described. At the moment (Begin 2016 and FreeCAD 0.16dev) the only supported solver by the FEM Module is [CalculiX]. Depending on the operating system you are working with you need to install CalculiX first. Check out [FEM Install].
Interfaccia
L'interazione tra il module FEM e CalculiX avviene con un file di testo. Il modulo FEM scrive un file di input CalculiX, avvia CalculiX, registra l'output di CalculiX e legge i file di output di CalculiX se sono disponibili. Lo strumento Calcola gestisce l'intero processo. L'interazione dell'utente nel processo è possibile.
Interfaccia di Pre-processo
CalculiX usa il formato abaqus come file di input. Prima di avviare il risolutore è possibile modificare il file di input. Le unità utilizzate nel file di input di CalculiX sono independenti dalle unità utilizzate in FreeCAD. Esse sono in mm e in N. (Da fare: check this. What happens with the mesh if inch is used in FreeCAD. Density was introduced. With this we have kg and s and no longer N?! how about this !?!)
L'interfaccia Modulo FEM - CalculiX supporta i seguenti oggetti:
FEM Elements
- Tet4 e Tet10 --> FEM_Mesh#Tetrahedron_element Tetrahedron
- S3 e S6 così come B31 e B32 sono in fase di sviluppo
Analisi
- analisi statica lineare
Materiali
- materiale isotropo elastico lineare (uniformità in tutte le direzioni)
- materiale multiplo è in fase di sviluppo
Interfaccia di post-processo
legge lo stress risultante (Von Mises) e tutti i movimenti