Draft Snap/sv: Difference between revisions

From FreeCAD Documentation
(Updating to match new version of source page)
(Created page with "Snäppa innebär att din nästa 3d punkt "klistras" på en existerande punkt.")
Line 1: Line 1:
Snäppa innebär att din nästa 3d punkt "klistras" på en existerande punkt.
Snapping means "gluing" your next 3d point onto an existing point. Snapping is available with most [[Draft Module|Draft]] and [[Arch Module|Arch]] tools, and can be enabled and disabled globally with the [[#Options|Draft ToggleSnap]] command. Each snap location below can also be enabled or disabled individually by clicking the corresponding button on the snap toolbar.


[[Image:Draft_Snap_example.jpg]]
[[Image:Draft_Snap_example.jpg]]

Revision as of 17:26, 18 February 2014

Snäppa innebär att din nästa 3d punkt "klistras" på en existerande punkt.

Available snap locations

Options

  • File:Snap Lock.png Lock: turns snapping on/off globally
  • Certain additional snap locations can be obtained by combining 2 snap locations, such as ortho + extension, that will give you a snap point at the intersection of their imaginary lines.
  • Other, more complex snap locations can also be obtained by using constraining (by pressing SHIFT or X or Y or Z while drawing).
  • The maximum distance at which a point is snapped a snap location is specified in the preferences, and can also be changed on-the-fly by pressing [ or ] keys.