Rysunek Roboczy: Kreskowanie

From FreeCAD Documentation
Revision as of 11:37, 29 September 2021 by FuzzyBot (talk | contribs) (Updating to match new version of source page)

Description

Draft objects with a DANEMake Face property can display an SVG pattern instead of a solid face color.

An ellipse and a polygon with an SVG pattern

Usage

  1. Make sure the objects are closed and planar, and do not self-intersect.
  2. To close a Draft Wire, a Draft BSpline, a Draft CubicBezCurve or a Draft BezCurve set its DANEClosed property to true.
  3. To close a Draft Circle or a Draft Ellipse set its DANEFirst Angle and DANELast Angle properties to the same value.
  4. Select the objects.
  5. Switch to the View tab of the Property editor.
  6. The WIDOKDisplay Mode must be set to Flat Lines.
  7. Select a WIDOKPattern.
  8. Optionally change the WIDOKPattern Size. Note that a higher value results in a denser pattern.
  9. The pattern is not displayed when the objects are selected. Deselect them to check the result.
  10. Optionally reselect the objects to change the pattern properties.

Available patterns

Notes

  • SVG patterns are stored in .SVG files. It is possible to use your own custom patterns. See Preferences.
  • The patterns themselves are not saved in the FreeCAD document. Objects whose WIDOKPattern cannot be found are displayed with a solid face color instead.

Preferences

See also: Preferences Editor and Draft Preferences.

  • To specify a directory with addition SVG patterns: Edit → Preferences... → Draft → Visual settings → Alternate SVG patterns location. Select a file in the directory and then remove the filename in the preferences input box, leaving only the path. After changing this preference you must restart FreeCAD.
  • The Edit → Preferences... → Draft → Visual settings → SVG pattern resolution preference is not used.
  • To change the WIDOKPattern Size used for new objects: Edit → Preferences... → Draft → Visual settings → SVG pattern default size.