Draft Snap Endpoint/de: Difference between revisions
No edit summary |
(Created page with "===Beschreibung=== Dieser Objektfang-Modus lässt Dich die Endpunkte von Elementen wählen.") |
||
Line 4: | Line 4: | ||
{{GuiCommand/de|Name/de=Draft Endpunkt|Workbenches=[[Draft Module/de|Draft]], [[Arch Module/de|Arch]]|MenuLocation=Entwurf → [[Draft Snap/de|Objektfang]] → Endpunkt|Shortcut=|SeeAlso=}} |
{{GuiCommand/de|Name/de=Draft Endpunkt|Workbenches=[[Draft Module/de|Draft]], [[Arch Module/de|Arch]]|MenuLocation=Entwurf → [[Draft Snap/de|Objektfang]] → Endpunkt|Shortcut=|SeeAlso=}} |
||
=== |
===Beschreibung=== |
||
Dieser Objektfang-Modus lässt Dich die Endpunkte von Elementen wählen. |
|||
This snap mode lets you select the endpoints of elements. |
|||
Revision as of 19:28, 3 January 2019
Draft Endpunkt |
Menüeintrag |
---|
Entwurf → Objektfang → Endpunkt |
Arbeitsbereich |
Draft, Arch |
Standardtastenkürzel |
Keiner |
Eingeführt in Version |
- |
Siehe auch |
Keiner |
Beschreibung
Dieser Objektfang-Modus lässt Dich die Endpunkte von Elementen wählen.
Use
- Make sure snap mode is turned on
- Choose element to be inserted into the FreeCAD-document
- Move cursor near one of the endpoints you wish to attach your element to
- Below on the right side of the cursor the symbol of the snap mode will appear
- Click to attach your element to the selected endpoint of target element
Notes
Snap mode can be used with
- sketcher elements (lines, arcs)
- draft elements (DWires, Lines, Arcs, Bezier Curves)
- edges of shapes
- edges of solids
Clicking on the snap-mode icon will toggle the snap mode on/off.