Draft Snap Endpoint/de: Difference between revisions

From FreeCAD Documentation
(Created page with "<br />")
 
(Created page with "{{GuiCommand/de|Name=Draft Endpoint|Workbenches=Draft, Arch|MenuLocation=Draft → Snap → Endpoint|Shortcut=|SeeAlso=}}")
Line 1: Line 1:
<br />
<br />


{{GuiCommand|Name=Draft Endpoint|Workbenches=[[Draft Module|Draft]], [[Arch Module|Arch]]|MenuLocation=Draft → [[Draft Snap|Snap]] → Endpoint|Shortcut=|SeeAlso=}}
{{GuiCommand/de|Name=Draft Endpoint|Workbenches=[[Draft Module|Draft]], [[Arch Module|Arch]]|MenuLocation=Draft → [[Draft Snap|Snap]] → Endpoint|Shortcut=|SeeAlso=}}


===Description===
===Description===

Revision as of 11:04, 17 May 2016


Draft Endpoint

Menüeintrag
Draft → Snap → Endpoint
Arbeitsbereich
Draft, Arch
Standardtastenkürzel
Keiner
Eingeführt in Version
-
Siehe auch
Keiner

Description

This snap mode lets you select the endpoints of elements.


Use

  1. Make sure snap mode is turned on
  2. Choose element to be inserted into the FreeCAD-document
  3. Move cursor near one of the endpoints you wish to attach your element to
  4. Below on the right side of the cursor the symbol of the snap mode will appear
  5. Click to attach your element to the selected endpoint of target element

Notes

Snap mode can be used with

  • sketcher elements (lines, arcs)
  • draft elements (DWires, Lines, Arcs, Bezier Curves)
  • edges of shapes
  • edges of solids

Clicking on the snap-mode icon will toggle the snap mode on/off.