Draft Constrain/sv: Difference between revisions
Renatorivo (talk | contribs) (page) |
(Updating to match new version of source page) |
||
| Line 1: | Line 1: | ||
To use constraining, press {{KEY|SHIFT}} while drawing. |
|||
[[Image:Draft_Constrain_example.jpg]] |
[[Image:Draft_Constrain_example.jpg]] |
||
In all tools that support constraining, you can force the next point to be constrained horizontally or vertically in relation to the last point entered. The vertical or horizontal constraining depends on where your mouse lies when you press {{KEY|SHIFT}}. If you are more north or south from the last point, it will be vertical. If you are more east or west, it will be horizontal. To change, just release {{KEY|SHIFT}} and press again at another location. |
|||
I alla verktyg som stöder begränsning, så kan du tvinga nästa punkt att begränsas horisontellt eller vertikalt i relation till den sist inmatade punkten. Den vertikala eller horisontella begränsningen beror på var musmarkören är när du trycker på {{KEY|SKIFT}}. Om du är norr eller söder om den sista punkten, så kommer begränsningen att bli vertikal. Om du är mer åt öster eller väster, så kommer den att bli horisontal. för att ändra, släpp {{KEY|SKIFT}} och tryck ned igen när musmarkören har en annan position. |
|||
Some tools, like [[Draft_Offset|offset]] and [[Draft_Trimex|trimex]] use constraining differently. They do not constrain vertically or horizontally but use a different way more adapted to the particular tool, like for example constraining the operation to a certain polyline segment. |
|||
| ⚫ | |||
{{languages/sv | {{de|Draft Constrain/de}} {{en|Draft Constrain}} {{es|Draft Constrain/es}} {{fr|Draft Constrain/fr}} {{it|Draft Constrain/it}} }} |
|||
{{clear}} |
|||
| ⚫ | |||
<languages/> |
|||
Revision as of 17:30, 18 February 2014
To use constraining, press SHIFT while drawing.
In all tools that support constraining, you can force the next point to be constrained horizontally or vertically in relation to the last point entered. The vertical or horizontal constraining depends on where your mouse lies when you press SHIFT. If you are more north or south from the last point, it will be vertical. If you are more east or west, it will be horizontal. To change, just release SHIFT and press again at another location.
Some tools, like offset and trimex use constraining differently. They do not constrain vertically or horizontally but use a different way more adapted to the particular tool, like for example constraining the operation to a certain polyline segment.