Draft Constrain/fr: Difference between revisions

From FreeCAD Documentation
(Created page with "Une autre façon de sélectionner des points plus précis consiste à limiter le mouvement du pointeur dans une direction X, Y ou Z particulière.")
(Created page with "== Contraintes horizontales et verticales ==")
Line 14: Line 14:
Une autre façon de sélectionner des points plus précis consiste à limiter le mouvement du pointeur dans une direction X, Y ou Z particulière.
Une autre façon de sélectionner des points plus précis consiste à limiter le mouvement du pointeur dans une direction X, Y ou Z particulière.


== Contraintes horizontales et verticales ==
== Horizontal and vertical constraints ==


[[Image:Draft_Constrain_example.jpg]]
[[Image:Draft_Constrain_example.jpg]]

Revision as of 16:39, 1 September 2019

Description

Les outils Atelier Draft vous permettent de sélectionner graphiquement les points, les distances, les rayons et les angles en cliquant sur la vue 3D avec le pointeur.

Toutefois, quand ces paramètres nécessite la précision, il est possible de saisir des Coordonnées Draft exactes dans la fenêtre de dialogue de l'outil.

Une autre façon de sélectionner des points plus précis consiste à limiter le mouvement du pointeur dans une direction X, Y ou Z particulière.

Contraintes horizontales et verticales

Perpendicular lines that were created by constraining the position of the points orthogonally

Hold the Shift key while drawing to force the next point to be constrained horizontally (X direction) or vertically (Y direction) in relation to the last point entered. The horizontal or vertical orientation depends on the position of the pointer when you press Shift; if you are more east or west from the last point, it will be horizontal; if you are more north or south, it will be vertical. To change the orientation, just release Shift, move the pointer to a new location, and hold Shift again.

Some tools like Draft Offset and Draft Trimex use constraining differently. They do not constrain vertically or horizontally but use a different method more adapted to the particular tool, for example, constraining the operation to a certain line segment.

While constraining the movement of the pointer, the Taskview panel will lock the coordinate values that are not being modified. For example, if using a horizontal constraint, only the X value changes, while the Y and Z values remain at their original relative or absolute coordinates, depending on whether relative mode is active or not.

File:Draft Constrain Shift Taskview example.png

Taskview when using a horizontal constraint while holding the Shift key

X, Y, Z constraints

Press one of the X, Y or Z keys after a point to constrain the next point on the specified X, Y, or Z direction. Press the same key again to release the constraint.

Pressing X or Y is equivalent to holding Shift and constraining horizontally or vertically, respectively.

Taskview when using a vertical constraint after pressing the Y key