Translations:Sketcher ConstrainCoincident/43/en

Some combinations which are not possible with a coincident constraint can be emulated using other constraints:

• The Symmetric constraint can be used to place a start point, end point or center point on the midpoint of a straight line.
• A midpoint-to-midpoint placement of two straight lines can be achieved by creating a new Point and using two Symmetric constraints so that it lies on the midpoint of both lines.
• A vertex can be constrained to lie along an edge using a PointOnObject constraint. Note that with this constraint, the point can lie anywhere on the full extension of a segment or curve (i.e. also before the start point or beyond the end point).
• A collinear placement of two straight lines can be obtained by applying a Tangent constraint to them, or by combining a PointOnObject constraint and a Parallel constraint.