# Translations:Draft Shape2DView/9/en

Jump to navigation
Jump to search

- Data
**Projection**: specifies the direction of the projection as a vector. For example, (0,0,1) is a projection looking through the Z axis, which would be projected on the XY plane; (1,0,0) is a projection looking through the X axis, which would be projected on the YZ plane; (0,1,0) is a projection looking through the Y axis, which would be projected on the XZ plane. The values can also be negative, in which case the direction of projection is inverted. - Data
**Projection Mode**: it can be "Solid", "Individual Faces", "Cutlines", and "Cutfaces".- The default projection is "Solid", which projects the entire selected shape.
- If only some faces of the base object are selected, the "Individual Faces" mode will project only those faces.
- If the selected object is an Arch SectionPlane, the "Cutlines" mode will project only the edges being cut by the section plane.
- If the selected object is an Arch SectionPlane, the "Cutfaces" mode will display the cut areas of solids as faces.

- Data
**In Place**: if it is`true`

, together with "Cutlines" or "Cutfaces" modes, the resulting projection will appear co-planar with the Arch SectionPlane. introduced in version 0.17 - Data
**HiddenLines**: if it is`true`

it will show the hidden lines of the projection. - Data
**Tessellation**: if it is`true`

it will perform tessellation of ellipses and splines, that is, it will represent curves with very fine line segments.

*Note:*this may be computationally intensive if Data**Segment Length**is very small.

- Data
**Segment Length**: specifies the size in millimeters of linear segments if Data**Tessellation**is`true`

.

*Note:*set a larger value first, and then change it to a smaller value to get better resolution.

- Data
**Visible Only**: if it is`true`

the projection will be recomputed only if it is visible.