Translations:Draft Rectangle/5/ro

From FreeCAD Documentation

Opțiuni

  • Press X, Y or Z after a point to constrain the next point on the given axis.
  • To enter coordinates manually, simply enter the numbers, then press ENTER between each X, Y and Z component.
  • Press R or click the checkbox to check/uncheck the Relative button. If relative mode is on, the coordinates of the next point are relative to the last one. If not, they are absolute, taken from the (0,0,0) origin point.
  • Press T or click the checkbox to check/uncheck the Continue button. If continue mode is on, the Rectangle tool will restart after you finish or close it, allowing you to draw another one without pressing the Rectangle button again.
  • Press CTRL while drawing to force snapping your point to the nearest snap location, independently of the distance.
  • Press SHIFT while drawing to constrain your next point horizontally or vertically in relation to the last one.
  • Press I or the Filled button to have the rectangle filled with a face after it has been closed.
  • Press ESC or the Cancel button to abort the current Line command.
  • Rectangles, when in "Flat Lines" display mode, can display a hatch pattern, by setting their "Pattern" property.