Translations:Basic Sketcher Tutorial/26/en
10. Adjust the angle between the construction lines.
- 10.1. Select the vertical construction line and the construction line closest to it.
- 10.2. Press Angle.
- 10.3. Set the angle to
72°
. - 10.4. Repeat the same procedure for each pair of construction lines, and use the same angle.
- Note: at this stage, the sketch may have very few degrees of freedom left, meaning that its shape cannot be changed too much. If you attempt to add more constraints, these may cause a conflict with the previously added constraints. If this is the case, do not add these constraints, and proceed with the next steps.