Rectângulo

From FreeCAD Documentation
This page is a translated version of the page Sketcher CreateRectangle and the translation is 9% complete.
Outdated translations are marked like this.

Sketcher CreateRectangle

Veja também
Sketch → Sketcher geometries → Create rectangle
Bancadas de trabalho
Sketcher
Atalho padrão
R
Introduzido na versão
-
Veja também
Sketcher Polyline

Description

This tool draws a rectangle by picking two opposite points. When starting the tool, the mouse pointer changes to a white cross with a red rectangle icon. The coordinates of the pointer are shown beside it in blue in real time.

To define a rectangle via a center point and an edge point, use the Centered rectangle tool.

Usage

  • After pressing the Create rectangle toolbar button, click once to set the first corner, then move the mouse and click a second time to set the opposite corner.
  • Pressing Esc or clicking the right mouse button cancels the function.

Notes

  1. A Mode spinbox to chose one of the modes to draw the rectangle:
    • Corner, length & width
    • Center, length & width
    • 3 corners
    • Center and two corners
  2. A Rounded corners checkbox to apply round corners to the rectangle.
  3. A Frame checkbox to add a contour with a constant offset to the (rounded) rectangle.
  • All three buttons in this selection now launch the same tool but with different preset combinations of mode and options that can still be altered after the first click.
  • If Rounded corners is enabled, the offset is inward, and the offset value is larger than the corner radius, the offset contour will be created without fillets.
  • The modes 3 corners, and Center and two corners create parallelograms rather than rectangles.