FEM Показать результат

From FreeCAD Documentation
This page is a translated version of the page FEM ResultShow and the translation is 29% complete.
Outdated translations are marked like this.
Other languages:

FEM ShowResult

Системное название
FEM ResultShow
Расположение в меню
Results → Показать результаты
Верстаки
FEM
Быстрые клавиши
S R
Представлено в версии
-
См. также
FEM tutorial

Описание

The ResultShow command opens the dialog for a FEM results object. A Result object is automatically created when a FEM analysis was performed using either the solver Calculix or Z88.

A Result object holds the resulting mesh and can visualize the results. It is designed and therefore limited to thermomechanical results. Except for the Solver Elmer, it can be used as an alternative to a result pipeline. A result pipeline can be used to visualize any kind of results (also electrical etc.).

The units used for the Result object are those of the set unit system while for result pipelines, the units are SI.

The visualization of the results is only active when the dialog is open. However, the dialog settings are stored in the FreeCAD model file.

Применение

To show the result dialog, select the result object in the Tree view, then either press the toolbar button Show result or use the menu Results → Show result (sortcut R then S). Alternatively you can also double-click on the result object in the tree view.

When the dialog is open, the result mesh will automatically be shown.

The dialog is shown at the left and offers the following features:

  • Select a result type and the minimum and maximum will be displayed in the dialog. The result mesh will be colored accordingly.
  • Click on the button Histogram to get a histogram what amount of result mesh nodes have a certain result. The histogram plot can be modified by the buttons in its toolbar. it is also possible to save the histogram as image using the save button from its toolbar.
  • Check the option Show to enable the slider and to visualize the result mesh deformation. The slider value is a factor with which the result Displacement Magnitude is multiplied.
    Note: The slider only affects the Displacement Magnitude, not its X, Y, Z components.
  • With the button Calculate you can perform calculations of the results. Input in the text box below the button an equation of your choice. Predefined is the equation P1-P3. This means the result Min Principal Stress is subtracted from the Max Principal Stress. The variables for the possible results are explained in the box User defined equation.
    After you input an equation press the button and the result will be shown in the fields displaying the minimum and maximum. The result mesh will be colored accordingly.
    Note: The calculation results always have the unit MPa, mm or T, no matter what unit system you use.