However, when these parameters need to be precise, it is possible to enter the exact Draft Coordinates in the dialog for the tool.
Another way of selecting more precise points is by constraining the movement of the pointer to a particular X, Y, or Z direction.
Horizontal and vertical constraints
Perpendicular lines that were created by constraining the position of the points orthogonally
Hold the key while drawing to force the next point to be constrained horizontally (X direction) or vertically (Y direction) in relation to the last point entered. The horizontal or vertical orientation depends on the position of the pointer when you press ; if you are more east or west from the last point, it will be horizontal; if you are more north or south, it will be vertical. To change the orientation, just release , move the pointer to a new location, and hold again.
Some tools like Draft Offset and Draft Trimex use constraining differently. They do not constrain vertically or horizontally but use a different method more adapted to the particular tool, for example, constraining the operation to a certain line segment.
While constraining the movement of the pointer, the Taskview panel will lock the coordinate values that are not being modified. For example, if using a horizontal constraint, only the X value changes, while the Y and Z values remain at their original relative or absolute coordinates, depending on whether relative mode is active or not.
Taskview when using a horizontal constraint while holding the Shift key
X, Y, Z constraints
Press one of the, or keys after a point to constrain the next point on the specified X, Y, or Z direction. Press the same key again to release the constraint.
Pressingor is equivalent to holding and constraining horizontally or vertically, respectively.
Taskview when using a vertical constraint after pressing the Y key