Translations:Draft Workbench/62/en

From FreeCAD Documentation
Revision as of 20:24, 5 October 2020 by FuzzyBot (talk | contribs) (Importing a new version from external source)
  • Toggle snap: toggles object snapping globally on or off.
  • Endpoint: snaps to the endpoints of line, arc and spline segments.
  • Midpoint: snaps to the middle point of line and arc segments.
  • Center: snaps to the center point of arcs and circles.
  • Angle: snaps to the special cardinal points of circles and arcs, at 45° and 90°.
  • Intersection: snaps to the intersection of two line or arc segments. Hover the mouse over the two desired objects to activate their intersection snaps.
  • Perpendicular: on line and arc segments, snaps perpendicularly to the latest point.
  • Extension: snaps on an imaginary line that extends beyond the endpoints of line segments. Hover the mouse over the desired object to activate its extension snap.
  • Parallel: snaps on an imaginary line parallel to a line segment. Hover the mouse over the desired object to activate its parallel snap.
  • Special: snaps on special points defined by the object. introduced in version 0.17
  • Near: snaps to the closest point or edge on the nearest object.
  • Ortho: snaps on imaginary lines that cross the last point, and extend at 0°, 45° and 90°.
  • Grid: snaps to the intersections of the grid lines, if the grid is visible.
  • Working plane: always places the snapped point on the current working plane, even if you snap to a point outside that working plane.
  • Dimensions: shows temporary X and Y dimensions while snapping.
  • Toggle grid: toggles the visibility of the grid on or off.