Croquizador CrearArcoDeElipse

From FreeCAD Documentation
Revision as of 18:05, 30 December 2020 by FuzzyBot (talk | contribs) (Updating to match new version of source page)

Arco de elipse Sketcher

Ubicación en el Menú
Sketch → Geometrías de croquis → Crear un arco de elipse
Entornos de trabajo
Sketcher
Atajo de teclado por defecto
Ninguno
Introducido en versión
0.15
Ver también
Elipse, Arco

Descripción

This tool draws an arc of ellipse by picking four points: the center, the end of major radius, the start point and the end point. When starting the tool, the mouse pointer changes to a white cross with a red ellipse arc icon. Besides are coordinates shown in real time.

The sequence of clicks is indicated by yellow arrows with numbers. C is the center, a - major diameter, b - minor diameter, F1, F2 are foci.

Utilización

  • Press the Arc of ellipse button.
  • First click in 3D view sets ellipse center. Second click sets the first radius and orientation of the ellipse. Third click sets the other radius and the start of the arc. The fourth click sets the end of the arc.
  • After the fourth click, the arc of ellipse is created, together with a set of construction geometry aligned to it (major diameter, minor diameter, two foci). The construction geometry can be manually deleted if not needed, and recreated later. See Internal Alignment Constraint and Sketcher Show Hide Internal Geometry.
  • Pressing ESC or clicking the right mouse button cancels the function.

Peculiarities

  • Major and minor axes of underlying ellipse are strict and cannot be swapped by resizing. The underlying ellipse must be rotated to swap the axes.
  • Unlike ellipse that can be constrained to become a circle, ellipse arc cannot represent an arc of circle.
  • Moving the arc of ellipse by edge is the same as moving ellipse's center.