Path: Buzunar/Cavitate 3D

From FreeCAD Documentation
Revision as of 20:26, 24 February 2020 by FuzzyBot (talk | contribs) (Updating to match new version of source page)

This documentation is not finished. Please help and contribute documentation.

GuiCommand model explains how commands should be documented. Browse Category:UnfinishedDocu to see more incomplete pages like this one. See Category:Command Reference for all commands.

See WikiPages to learn about editing the wiki pages, and go to Help FreeCAD to learn about other ways in which you can contribute.

Path 3DPocket

Menu location
Path → 3D Pocket
Workbenches
Path
Default shortcut
None
Introduced in version
-
See also
None

Descriere

Acest instrument crează o operație tip un buzunar 3D. Un buzunare 3 D ia în considerarea suprafața inferioară a buzunarului

Utilizare

  1. Selectați partea de jos a buzunarului pe care doriți să-l muriți
  2. Apăsați tasta 3D Pocket .
  3. Selectați controlerul de instrumente pe care doriți să-l utilizați
  4. Reglați proprietățile dorite
  5. Aplicați
  1. From within a Job, select one or more Faces from the Job Model to include as the Base Geometry.
  2. Invoke the Pocket 3D or select Path Pocket 3D command from the top menu.
  3. Choose a Tool controller from the pop up selection dialogue window.
  4. Add or subtract Base Geometry elements as needed to configure the Operation.
  5. Check the Depths tab to ensure the Start Depth, Finish Depth, and Step Down percentage are correct. The Final Depth is determined by the Body Geometry selection and is not modifiable.
  6. Check the Heights tab to ensure the Safe and Clearance Heights are appropriate.
  7. Check the Operation tab where the Tool controller can be re-selected, the Cut mode can be configured for Climb or Conventional milling, the Pattern can be set, the Step Over percentage can be adjusted, and Pass Extension can be applied.
  8. Click Apply to observe the milling path for the passes of the Operation. Adjust parameters until satisfied with the Operation.
  9. Click OK to save the Operation.

Notes

  • All paths generated from this operation are based on a standard end mill using the diameter of the tool you selected for this 3D Pocket operation.
  • Ball end mills and other shapes are not respected for path generation even if selected as the tool for this operation.

Options

Empty

Properties

Data

Empty

View

Empty

Scripting

See also: FreeCAD Scripting Basics.

Example:

#Place code example here.