Draft: Trimex

From FreeCAD Documentation
Revision as of 04:20, 21 February 2020 by FuzzyBot (talk | contribs) (Updating to match new version of source page)

Draft Trimex

poziția meniului
Draft → Trim/Extend
Ateliere
Draft, Arch
scurtătură
T R
Prezentat în versiune
-
A se vedea, de asemenea,
Part Extrude

Descriere

Acest instrument taie/scurtează și/sau extinde linii și polilinii, și extrudează fațete.

The Trimex tool also extrudes faces created from closed wires. In this sense, it's similar to Part Extrude and to PartDesign Pad.

Wire segment extended, then wire segment trimmed; face extruded into a solid body

Cum se folosește

  1. Selectați filamentul/polilinia pe care doriți să-l tăiați sau extindeți sau selectați o fațetă pe care doriți să o extrudați
  2. Apăsați butonul Draft Trimex sau apăsați tatele T apoi R
  3. Faceți clic pe un punct din vizualizarea 3D

Trimming or extending is decided from the position of the pointer.

  • If the line is short it can be extended to approach and cross another line.
  • If the line is long and crosses another line, the excess length can be trimmed.
  • If the pointer is moved over another object or edge, the trim-extend operation will snap to that object, so that the trimmed or extended line ends exactly at the intersection with the object. This snapping works even without Draft Snap modes active.

A Draft Wire allows you to trim or extend any of its individual segments, which may affect the entire shape of the wire. In this case, the Trimex tool will work on the line segment that is closer to the pointer. Hold the Shift key to keep trimming or extending the current segment independently of the position of the pointer.

When the selected object is a face, the Trimex tool switches to extrude mode. In extrude mode the extrusion is done in the direction of the normal of the face. For example, if a rectangle lies on the XY plane, it should be extruded in the Z direction. To do this correctly, pressing the Z key may be necessary to constrain the distance to the Z direction. Alternatively, hold the Shift key to extrude in any direction that is not the normal.

Opţiuni

  • tăierea sau extinderea este decisă automat din poziția mouse-ului
  • dacă mutați cursorul mouse-ului peste un alt obiect, operația de ajustare / extindere se va apropia de acel obiect sau segment
  • apăsând SHIFT va constrain pe segmentul în curs de curățare sau extindere
  • apăsând ALT va inversa direcția de tăiere
  • Când obiectul selectat este o față sau o față este selectată dintr-un obiect existent, instrumentul trimex trece în modul extruder. În modul extrudat, apăsarea tastei SHIFT eliberează extrudarea de pe fața normală și permite fixarea în altă parte.

Scrip-Programare

Nu este disponibil. A se vedea instrumentul Part Extrude.